To ensure the proper operation and processing quality of the tube end forming machine, operators should pay attention to the following points:
1. Equipment Inspection: Regularly check the motor, power cord, lubricating oil, hydraulic oil, etc. to ensure the equipment is in good condition.
2. Mold Installation and Commissioning: Properly install the mold, adjust the clamping frame and press die, and ensure a secure mold clamp and appropriate system pressure.
3. No-load Test Run: Before full production, perform a no-load test run to check the operation of the motor, gearbox, and other equipment to ensure there are no abnormalities.
4. Safe Operation: During operation, strictly adhere to safety operating procedures, wear personal protective equipment, and avoid placing any part of your body within the range of the mold or clamping device.
5. Daily Maintenance: Regularly inspect and remove debris and debris from the forming mold to keep the equipment clean to prevent damage to the tube end surface and the mold.
